![]() Keyless Entry Touchscreen Hinges Pocket Door Screen Door. Mechanism within the mortise lock is slightly miss-aligned, screwing the side plate onto the lock can cause it to become jammed. Ideal for security and privacy, mortise locks are a highly functional lock option for doors. Replace the side cover and secure with the screw.īefore fitting the mortise lock to a door, check that the handle cam moves freely and that the lock is functioning - if the Mortise locks require box to be mortised out of the edge of your door that is around 6 tall and 3 1/2 deep to allow the mortise lock box to slide into the. ![]() Of the lock - make sure that it is positioned to operate the latch. If the door handle cam is to be positioned above the latch (as shown here), relocate it in the hole in the backplate Using fingers, small pliers or similar, push the locator against the spring and re seat the locator. Position the spring and locator in the back of the latch and fit the latch into the lock in the required orientation. The lock - make sure that it is orientated to accept the latch. Also available with aluminum, zinc, brass, bronze, or stainless steel lever handles or paddles (5PD only). Find the right lock for your exterior and interior. Mortise type Series 4, 5, 5PD and 5SS50 with 3/4 in latch bolts. If the door handle cam was originally positioned above the latch, relocate it in the hole in the backplate of Browse our selection of premium, secure door locks, entry door knobs and modern hardware from Schlage. If the door handle cam was positioned under the latch (as shown above), lift it off - it will go back after the latch has been refitted. The two orientations of the mortise lock latch are shown to the right. if it was uppermost before, turn it over so that the curve is facing down or visa versa). Remove the latch from the lock and turn the latch over so that the curved side of the latch is reversed (i.e. NOTE that care is needed to ensure that the spring does not fly off with the locator. Through Spindle This long rod that connects the handles/knobs through the door and mortise lock body. Handle/Knobs The device that you will turn in order to retract the latch once the door is unlocked. Using a small screwdriver push the locator against the spring towards the latch to unseat the locator. Lock Body The housing for the bolt work, which are the components that will disengage and engage the lock. Latch, lift it off and put it to one side - it will go back before the reversed latch is fitted (the cam is shown right under If the door handle cam is positioned above the The latch is normally held in place within the lock by a spring over a locator. Release the screw holding the side plate on to the lock and lift off the side plate. In a mortise lock to suit any application. Howeverĭoors may be hinged on the left or right so the latch as supplied may not be suitable. On a mortise lock, the curved side of the latch needs to meet the striker plate on the door jamb when the door is closed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |